Acura Integra 1998 Service Manual page 1342

v
-t f-
-.l r --1 f-
M.in cod. {11 S!b{od.
(2}
o T c r 2
-l
F
--{ F
Main cod. (l)
Sub-cod.11)
.--.Y-
oTc r-r
Thnd'm6r.@6m
2
O N
light sl.ys on h ct36 or
Troubleshooting
Reading the DTC (cont'd)
B. The SRS indicator light can also indicate the OTC by the number of blinks when the SCS service connector ts connect-
ed to the service check connector (2P).
1. Turn the ignition switch OFF, and wait for ten seconds. Then connect the SCS service connector to the service check
connector (2P). lf you do not wait ten seconds, the SRS unit will not be completelv reset and will not outout DTCS.
SRS INDICATOR LIGHT
scs SERV|CE
CONI{ECTOR
- (x)l01(x)
SERVICE CHECK
CONNECTOR (2PI
2. Turn the ignition swilch ON (ll). The SRS indicator light comes on for about six seconds and then goes off. Then it will
indicate the DTC:
- The DTC consists of a main code and a sub-code.
-
Including the most recent problem, up to three different malfunctions can be indicated.
-
ln case of a continuous failure, the DTC will be indicated repeatedly (see example 1 below).
-
In case of an intermiftent failure, the SRS indicator light will indicate the DTC one time. then it will stay on (see exarn-
ple 2 beiow).
-
lf both a continuous and an intermittent failure occur, both DTCS will be indicated as continuous failures.
-
In case the system is normal (no DTC), the SRS indicator light will stay on {see example 3).
3. Read the DTC.
4. Turn the ignition switch OFF, and wait for ten seconds. Then disconnect the SCS service connector from the service
check connector (2P),
Examples ol DTC Indications:
L Continuous failure, SRS Indicator Light is:
0.3 s 0.3s 0.3 s
-]-]-l-t-
07?M
(S./'
\
-l
Mlin cod.
r
orc 2-1
Mo3t r.cant probt.m
Intermittent failure, SRS Indicator Light is:
Normsl (no failure), SRS Indicator Light is:
oTc 5,r