Table of Contents
Advertisement
Countershaft:
1.
Bend the tab on the lock washer down, then remove
the bolt and bearing retainer plate.
CLUTCH
;:-<
I
I
l{oustNG
2.
Remove the needle bearing using the special
as shown, then remove the oil guide plate.
3/8- - 16 SLIDE HAMMER
lcommercially .vailablel
tools
ADJUSIABLE BEARING
PULLER,25-40 mm
07736
3.
Position the oil guide plate and new needle bearing
in the bore of the clutch housing, then drive in the
needle bearing using the special tools as shown.
NOTE: Position the needle bearing with the oil hole
f a c i n g u p .
NEEDLE
OIL HOLE
OIL GUIDE PLATE
CLUTCH
HOUSING
lnstall the bearing retainer plate and new lock wash-
er, then bend the tab against the bolt head.
8 x 1 . 0 m m
15 N.m 11.5 kgf.m, 11 lbtftl
LOCK
WASHER
Replace.
ATTACHMENT, 52 x 5s mm
1 3 € r
Advertisement
Table of Contents
Troubleshooting
