Table of Contents
Advertisement
J
1. Remove the final driven gear from the differential
carner.
NOTE: The final driven gear bolts have left-hand
threads.
2.
Pry the snap ring ofl differential carrier, then remove
the speedometer d.ive gear and 5 x 1O mm roller.
SNAP RING
DIFFERENTIAL
CARRIER
DRIVE GEAR
lnstall the 5 x 1O mm roller in the differential carrier.
Installthe speedometer drive gear with its chamfered
side facing the carrier. Align the cutout on the bore
of the speedometer drive gear with the 5 x 1O mm
ro er.
SPEEDOMETER
DRIVE GEAR
I n s t a l l i n t h i s
d i r e c t i o n .
Cutout
ROLLER,
5 x 1 0 m m
5. Align the hooked end ot the snap ring with the pin-
ion shaft as shown. then install the snap ring in the
dilJerential carrier groove.
H o o k e d e n d
SNAP RING
Install in this direction.
6 .
Install the final driven gear, then tighten the bolts
to the specified torque.
TOROUE: 103 N.m (10.5 kgt.m, 76 lbl.ttl
NOTE: The final driven gear bolts have left-hand
threads.
BOLTS
1 0 x 1 . 0 m m
103 N.m (10.5 kgf.m,
76 rbt.frl
Left-hand threads
FINAL DRIVEN
GEAR
Install in this direction.
DIFFERENTIAL
CARRIER
7.
Installthe ball bearings (see page 15-30).
Advertisement
Table of Contents
Troubleshooting
