Taillights (Hatchback)
Replacement
1 .
2 .
Open the rear hatch.
Remove the rear panel lining and the side lining (see
section 20).
Disconnect the 5P connector from the taillight.
Remove the six mounting nuts, then pull out the
taillight.
N O T E :
a lnspect the gasket. Replace it if it is distorted or
stays compressed.
a After installation, run water over the lights to
make sure they don't leak.
6P CONNECTOR
Replacement
Rear turn signal/Rear parking lighis.
1 . Open the rear hatch, then remove the access panel.
2. Remove the bulb from the bulb socket.
O : R E A R T U R N S I G N A L L I G H T B U L B ( 3 2 C P )
@ : R E A R P A R K I N G L I G H T B U L B { 3 C P )
Brake/Taillighr/Back-up
lights:
1 . O p e n t h e r e a r h a t c h .
2.
Remove the rear panel lining {see section 20).
( i ) : B A C K - U P L I G H T B U L B ( 3 2 C F ,
( D r B R A K E / T A I L L I G H T
B U L B ( 3 2 / 3 C P )
ACCESS PANEL
23-174
----