Acura Integra 1998 Service Manual page 1187

1. Disconnect the 3P connector from the vehicle speed
sensor (VSSl.
2. Remove the two mounting bolts, then remove the
V S S .
3P CONNECTOR
BOLT
9 . 8 N . m
( 1 . O k g f . m ,
22 tbt,ltl
DRIVE LINK
3 . Install in the reverse order of removal.
NOTE: The VSS drive link is a very small part;
careful not to lose it.
D C
Vehicle Speed Sensor (VSS)
Engine Oil Pressure
lndicator System
Replacement Engine Oil Pressure Switch Test
2 3 - 1 3 0
E-_
1 . Remove the YEL/RED wire trom the engine oil pres-
sure swlrcn.
ENGINE OIL PBESSURE SWITCH
Check for continuity between the positive terminal
and the engine (ground) with the ignition switch OFF.
a lf there is continuity, go to step 3.
a lf there is no continuity, replace the switch.
Check lor continuity again, this time with the engine
r u n n i n g .
a lf there is continuity, go to step 4.
a lf there is no continuity, the switch is OK.
Make sure engine oil level is OK, then check engine
oil pressure (see section 8).
a lf engine oil pressure is OK, replace the switch.
a lf engine oil pressure is low, check the engine oil
pump (see section 8) and, iI necessary, replace it.
2 .
3 .
POSITIVE TERMINAL