Table of Contents
Advertisement
6.
Remove the bracket and detach the grommets, then
carefully remove the plastic cover.
a : Grommet locations, 2
<: Screw locations, 2
A
: : )
I
@+) i
: )
7.
Before installing the plastic cover, make sure the
door harness and connectors are fastened correctly
on the door.
a: Connector clip locations, 2
O: Harness clip locations, 5
,[
,/
BRACKET
8.
Install the plastic cover and bracket.
N O T E :
a Apply adhesive along the edge where necessary
to maintain a continuous seal and prevent water
l e a k s .
a Do not plug the elongated hole.
a : Grommet locations, 2
q)
GROMMET
BBACKET
P a s s t h e d o o r
h a r n e s s t h r o u g h
t h e h o l e i n t h e
p l a s t c c o v e r .
9 .
'l o.
ELONGA
HOLE
Install the door panel (see page 20-32).
N O T E :
a Make sure the door harness is not pinched.
a l f n e c e s s a r y , r e p l a c e a n y d a m a g e d c l i p s .
a Make sure the connectors are connected properly.
Install the armrest pocket and inner handle trim (see
p a g e 2 0 - 3 2 ) .
NOTE: Make sure the connector ts connected
properly.
I
PLASTIC COVER
ADHESIVE
7/
20-33
Advertisement
Table of Contents
Troubleshooting
