Table of Contents
Advertisement
Troubleshooting
DTC 2-'l (cont'd)
From pago 23-313
Chack for e short to power in tho SRS mrin ham.3s:
1. Disconnect the battery negative csble, then disconnect
the positive cable, and wait for three minutes.
2. Disconnect the driver's airbag 2P connector trom the
cable roel 2P connector.
3. Disconnect the SnS main harness 18P connector from
the SRS unir.
4. Remove th€ special tool (2 O) from the SRS main harness
2P connector.
5. Reconnect the batt6ry positive cable, then reconnect the
negative cable.
6. Connect a voltfieter between the No. 10 (+) terminal of
SFS main harness 18P conn6ctor and ground.
7. Turn th6 ignition switch ON {ll), and measure vottage.
There should be 0.5 V or less.
8. Connect a voltmeter betwoen the No. 14 (+) terminal ol
the SRS main harness 18P connector and ground, and
measure
there should be 0.5 V or less.
SRS UNIT
SRS MAIN HARNESS
'8P CONNECTOR
Short to power in the SRS m.in harn.G; r6pl.c. th. SFS
main h!]nca3.
23-314
Advertisement
Table of Contents
Troubleshooting
