Acura Integra 1998 Service Manual page 1208

Shift Lock Solenoid Test/Beplacement
)
r-
)
2 .
1 . Remove the console, then disconnect the 2P con-
nector of the shift lock solenoid trom the main wire
harness.
NOTE: Do not connect power to the B (- ) terminal
(reverse polarity) or you will damage the diode in-
side the solenoid.
Connect battery power to the A terminal, ground the
B t e r m i n a l m o m e n t a r i l y , a n d c h e c k s o l e n o i d
operation.
a lf the solenoid does not operate, replace it as
described in steps 3,4, and 5.
a lf the solenoid does operate, check and, i{ neces
sary, adjust its two positions as shown in step 5.
3.
Remove the shift lock collar and the solenoid pin.
4.
Remove the selfiocking nuts and shift lock solenoid,
then installthe new solenoid in the reverse order of
r e m o v a l .
SHIFT LOCK
SOLENOID
SHIFT LOCK COLLAR
SELF-L NUTS
R e p l a c e .
9 . 8 N . m { 1 . 0 k g f . m ,
7.2 lbI.Ir)
5. Check and, if necessary, adiust the solenoid's po
sition.
a W h e n t h e s h i f t l o c k s o l e n o i d i s O N , c h e c k t h a t
t h e r e i s a c l e a r a n c e o f 2 . 5 ! O . 5 m m { 0 . 0 9 8 t
O.020 in) between the top rear corner oI the shilt
lock lever and the lock pin groove, then tighten
the self-locking nuts.
NOTE: Use new self-locking nuts.
2 . 5 t O . 5 m m
(0.098 I 0.020 in)
SHIFT
LEVER
LOCK
LOCK PIN GROOVE
a When the shift lock solenoid is OFF, make sure
that the lock pin is blocked by the shitt lock lever.
LOCK PIN
GROOVE
LOCK PIN
23-151