Acura Integra 1998 Service Manual page 587

I
20. Connect the vehicle speed sensor (VSS), mainshaft
speed sensor, and countershaft sDeed sensor con-
nectors.
VEHICLE SPEED SENSOR
CONNECTOB
)
k/
t"J
21. Connect the lock-up control solenoid valve connec-
tor and shift control solenoid valve conneclor, then
clamp the lock-up control solenoid harness with the
harness bracket.
22. Connect the transmission ground cable.
SPEED SENSOR
LOCK-UP CONTROL
SOLENOID VALVE
CONNECTOR
2 3 .
Connect the starter cable to the starter motor, and
install the cable holder.
NOTE: When installing the starter motor cable,
make sure that the crimped side ol the ring terminal
i s f a c i n g o u t ( s e e s e c t i o n 2 3 ) .
6 x 1 . 0 m m
12 N.m {1 .2 kgf.m, 8.7 lbl.ft)
9 N . m
(0.9 kgf.m, 7 lbt.ttl
STARTER CABLE
TERMINAL
STARTER CABLE
2 4 . Install the air cleaner housing assembly and intake
a r r o u c l .
AIR CLEANER HOUSING
INTAKE AIR
ASSEMBLY
2 7 .
Refill the transmission with ATF {see page 14-98).
Connect the battery positive (+ ) and negative { - }
cables to the battery.
Start the engine. Set the parking brake, and shift the
transmission through all gears three times.
Check shilt cable adjustment as described on page
1 4 - 1 7 6 .
Check the front wheel alignment (see section 18).
Let the engine reach operating temperature (the cool-
ing fan comes onl with the transmission in S or @
position, then turn it off and check the fluid level.
31. Road test as described on page 14-94 and 96.
2 5 .
26.
24.
2 9 .
3 0 .
1 4- 17 1