Acura Integra 1998 Service Manual page 1357

DTC 1-3
)
CAUTION: When€ver the ignition 3witch is ON (ll), or
has been turned OFF for le3s lhan three minute3, be
careful not to bump the SRS unit; the airbags could
accidontally d€ploy and cause damage or iniuries.
Chcck for a short to anothor wiro in the driver's airbag inlla-
tor:
1. Turn the ignition switch OFF.
2. Disconnect the battery negative cable, then disconnect
the positive cable, and wait tor three minutes.
3. Disconnect the driver's airbag 2P connector from the
cable reel 2P connector.
CAUTION: Do not diaconnocl the p.sseng.r'5 !irbaO
connoctor.
4. Connect the special tool {2 o} to the cable reel 2P connec'
tor,
5. Reconnect the battery positive cable, then reconnect the
negative cable.
SRS SIMULATOR
LEAD C
0?TAZ - SZ5011A
and SRS INFLATOR
SIMULATOR
t2 0 JACKI
07SAZ - T8,(}11A
)
Erase the DTC memory (see page 23-2891.
Road the DTC (see page 23-287).
o1
\
,"" rr*u,".
GoNNECTOR
12 0)
07TAZ - S250200
(cont'd)
SRS SIMULATOR
I.EAD C
orTAZ - SZ5011A
.nd SRS INFLATOR
SIMULATOR
12 0 JACKI
07SAZ-TBrl011A
TrVto reproduce the SRS indicator light:
1. Erase the DTC memory (see page 23-289).
2. Turn the ignition switch ON (ll), and checkthatthe SRS indi
cator light comes on for about six seconds and then goes
off.
Doss tho SRS indicato. liqht stav on?
Intormittent failure, 3yitom i3 OK at thk timo. S€a TrouH€-
Short in tho drivar's sirblg inflstor; replace the driv-
Chock for s shon in tho cablo rool:
'1. Disconnect the battery negative cable, then disconnect
the positive cable, and wait tor three minutes.
2. Disconnect the special tool (2 0) from the cable re€l 2P
connector,
3. Remove the dashboard lower cover, and disconnect lhe
cable reel 2P connector from the SRS main harness.
4. Connect the special tool (2 O) to the SRS main harness
To page 23-304
)
23-303