Acura Integra 1998 Service Manual page 1248

High Mount Brake Light Replacement (Bulb type)
Hatchback:
Sedan:
1 .
O p e n t h e h a t c h .
Remove the two clips and the cover.
R e m o v e t h e t w o n u t s a n d t h e h i g h m o u n t b r a k e
light, then disconnect the 2P connecror.
1 . Open the trunk lid, and disconnect the 2P connector
from the high mount brake light.
Remove the two nuts, then remove the high mount
brake light from the rear shelt.
2 .
3 .
2 .
2P CONNECTOR
Turn the socket 45o counterclockwise to remove the
b u l b .
Install the high mount brake light in the reverse or-
der of removal, and clean the rear window glass be-
tore installing.
CAUTION: When installing the high mount brake
light, make sure the rubber seal fits against the reai
window evenly.
3 . Install the high mount brake light in the reverse or
der of removal. Clean the rear window qlass belore
installing the light.
5 .
)
23-191