Heater Control Panel
Replacement
J
2 .
1 . Disconnect the air mix control cable from the heat
er unit (see page 21-27).
Remove the rear window delogger switch and the
hazard warning switch.
Remove the two self-tapping screws, then pull out
the heater control panel and the center air vent. Dis-
connect the connectors, and remove the heater con-
trol panel and the center air vent.
NOTE: The locking tabs of the hazard warning
switch and heater control panel connectors are on
the bottom.
CENTER AIR VENT
REAR WINDOW
D€FOGGER
swtrcH
HAZARD
WARNING
swrTcH
CONNECTORS
4.
Remove the four self-tapping screws and the center
atr vent.
Install in the reverse order of removal, and adjust the
air mix control cable at the heater unit (see page
2 1 - 2 7 1 . l t n e c e s s a r y , a d j u s t t h e h e a t e r v a l v e c a b l e
lsee page 21-27).
5 .
AIR MIX CONTROL CABLE
CENTER AIR VENT
21-25