Lnstallation - Acura Integra 1998 Service Manual

1 . Loosely install the
a l i g n i n g t a b f a c i n g
two flange nuts,
d a m p e r o n t h e f r a m e w i t h
i n s i d e , t h e n l o o s e l y i n s t a l l
t h e
t h e
2 . Install the damper fork over the driveshaft and onto
t h e l o w e r a r m . I n s t a l l t h e f r o n t d a m p e r i n t h e
damper fork so the aligning tab is aligned with the
slot in the damper fork.
Loosely install the flange bolt.
L o o s e l y i n s t a l l a n e w s e l f l o c k i n g n u t w i t h t h e
flange bolt.
Raise the knuckle with a floor jack until the vehicle
just lifts off the safety stand.
@
The ltoor jack must be securely posi-
tioned or personal iniury may result.
Tighten the flange bolt.
Tighten the self-locking nut.
Tighten the flange nuts on the top of the damper to
3 .
FLANGE NUTS
1 0 x ' 1 . 2 5 m m
49 N m 15.0 kgt m,36 lbtft)
Tighten to this torque in step 8.
4 .
5 .
6 .
7 .
8 .
the specified torque.
9. lnstall the brake hose mounts with the brake hose
mounting bolts.
ERAKE HOSE MOUNTING BOLT
18 x 20 mml
/GS, GsR, Type R Models: \
l g r 2 5 - - ,
22 N.m 12.2 kgt m, 16 lbf.ft)
BRAKE HOSE MOUNTING BOLT
{8 x 16 mm)
22 N.m {2.2 kgl.m, 16lbtft}
FLANGE BOLT
SELF.LOCKING NUT
12 x L25 mm
64 N.m (6.5 kgt m, 47 lbI.ftl
BOLT
1 0 x 1 . 2 5 m m
,|:} N.m {4.4 kstm, 32lbtft}
10. Install the front wheel (see page 18-17).
DAMPER
ALIGNING TA8
lnstallation
8-25