Rack Guide Adiustmont - Acura Integra 1998 Service Manual

Integra 1998
Hide thumbs Also See for Integra 1998:
Table of Contents

Advertisement

Rack Guide Adjustment
Fluid Replacement
Check the reservoir at regular intervals, and add fluid as
neceSsary.
CAUTION: Use only Genuine Honda Powel Ste€ring
Fluid-V. Using other fluids such as ATF or othor manu-
laclurer's power ste€ring fluid will damag€ the systom.
SYSTEM CAPACIW:
B18Gl ongine:
1.06lit€r (1.12 US. qt,0.93 lmp.qt)
Excopt 8l8Cl ongino:
1.0 lher (r.06 US. qt.0.88 imp.qtl
at disa$ombly
RESERVOIR CAPACITY:
0.,0 liter {0.42 US. qt, 0.35 lmp.qt}
LEVEL LINE
LEVEL LINE
Raise the reservoir and disconnect the return hose
that goes to the oil cooler.
Connect a hose of suitable diameter to the discon-
nected return hose and put the hose end in a suit-
able container.
CAUTION: Take care not to spill thq fluid on lhe
body and parts. Wipe off any spilled fluid al onc€.
Start the engine. let it run at idle, and turn the steer-
ing wheel from lock-to-lock several times. When
f l u i d s t o p s r u n n i n g o u t o f t h e h o s e , s h u t o f f t h e
engine. Discard the fluid.
2 .
RETURN HOSE
{ F r o m t h e o i l c o o l e r )
4.
Reinstallthe return hose on the reservoir.
5.
Fill the reservoir to the uDDer level line.
6.
Start the engine and run it at fast idle, then turn the
steering from lock-to-lock several times to bleed air
from the system,
7.
Recheck the fluid level and add some it necessary.
CAUTION: Do not lill the reservoir boyond thc
upper level line.
J .
4 .
NOTE: Perform rack guide adjustment with the wheels
in the straight ahead position.
1. Loosen the rack guide screw locknut with the spe-
cialtool, then loosen the rack guide screw.
Tighten the rack guide screw until it compresses the
spring and seats against the rack guide, then loosen
it.
R e t i g h t e n i h e r a c k g u i d e s c r e w t o 3 . 9 N . m ( 0 . 4
kgf.m, 2.9 lbi.ft), then back it ofl to specified angle.
Speciliad Roturn Anglo: 20' Max
Tighten th€ locknut while holding the rack guide
screw.
RACK GUIDE SCREW
2 5 N m
{2.5 kgf.m, 18 lbf ft)
LOCKNUT WRENCH. ilo mm
079't 6 - SA50001
E
6.
Check for tight or loose steering through the com-
plete turning travel.
Perform following inspections:
. Steering operation (see page 17-18).
a Power assist with car parked.
I

Advertisement

Table of Contents
loading

Table of Contents