Acura Integra 1998 Service Manual page 740

1 0 .
1 1 .
't2.
1 3 .
't 4.
Rear Suspension
Hub Bearing Unit {cont'dl
Remove the brake hose mounting bolt.
R e m o v e t h e c a l i p e r b r a c k e t m o u n t i n g b o l t s a n d
hang the caliper to one side.
CAUTION: To prevent accidenlal damage to the
caliper or brake hose, use a short piece of wire to
hang the caliper from the undgrcarriag€.
Screw two 8 x 1.25 mm bolts into the disc to push it
away from the hub.
NOTE: Turn each bolt two turns at a time to pre-
vent cocking the disc excessively.
Remove the brake disc.
Remove the hub unit from the knuckle.
BRAKE HOSE MOUNTING BOLT
1 0 x 1 . 2 5 m m
1 8 - 3 0
lnstallation
l. Install the hub unit, spindle washer and brake disc.
NOTE:
. Wash the bearing and spindle thoroughly in high
flash point solvent before reassembly.
. Before installing the brake disc, clean the mating
surfaces of the rear hub and the brake disc.
HUS UNIT
SPINOLE WASHER
I n s t a l l t h e b r a k e c a l i p e r w i t h t h e c a l i p e r b r a c k e t
mounting bolts.
Install the brake hose with the brake hose mounting
bolt.
CAUTION: Be careful not to twist the hos€ mor€
than nec€ssary.
CALIPER BRACKET MOUNNNG EOLTS
10 x 1.25 mm
56 N m 15.6 kgf.m, 41 lbt.ftl
^ r i
t , - - -
BRAKE DISC
BRAKE HOSE MOUNTING BOLT
22 N.m 12.2 kgt m. 16 lbf ftl