Acura Integra 1998 Service Manual page 726

Front Suspension
Knuckle/Hub (cont'd)
Knuckle lnstallation
1. lnstall the knuckle on the driveshaft.
2.
lnstall the knuckle on the lower arm and the tie-rod,
then tighten the nuts and install new cotter pins.
CAUTION:
. Be carelul not to damage tho ball ioint boot.
a Torque the castls nut to the lowel torque spgci-
fication, then tight€n it only far enough to align
the slot with the pin hole. Do not align the nut
by loosening.
NOTE: Wipe off the grease before tightening the
nut at the ball joint.
NUT
ri
10 x 1.25 mm
4il N.m (4.{ kgtm,32lbf.ftl
On reassembly,
bend the cotter pin
as shown.
CASTLE NUT
12 x 1 .25 mm
49 - 59 N.m (5.0 - 6.0 kgf m, 36 -,|i| lbf ft)
3.
Install the knuckle on the upper arm, then tighten
the castle nut and install a new cotter Din.
COTTER PIN
Replace.
On reassembly,
bend the cotter pin
CASTLE NUT
1 2 x 1 . 2 5 m m
39 - 47 N.m
{4.0 - 4.8 kgf.m,
29 - 3s rbr.ft)
;
, 'ar
COTTER PIN
1 8 - 1 6
4.
Install the wheel sensor with the sensor mounting
bolts (tor vehicles with ABS).
lnstall the sensor wire with the two 5 mm bolts (for
vehicles with ABS).
NOTE: Be careful when installing the sensors to
avoid twisting wires.
6 mm BOLTS
9.8 N.m 11.0 kgf.m,7 lbf.ftl
v _ )
SENSOR MOUNTING
BOLTS
9.8 N.m (1.0 kgf.m,7.2 lbl.ftl
6.
lnstall the brake disc with the 6 mm brake disc retain-
Ing screws.
NOTE: Before installing the brake disc, clean the
mating surfaces of the front hub and the brake disc.
6 mm BRAKE DISC
RETAINING SCREWS
9.8 N.m 11.0 kgl.m, 7.2 lbf'ftl