Abs Indicator Does Not Go Off - Acura Integra 1998 Service Manual

Troubleshooting
ABS Indicator Does Not Go Off
JUMPER
WIRE
ABS OO TNOL UMT 22P OO'{NECTOR
Wire side of temalo terminalg
A8S COI{TROL Ut{lT 12P OO I{ECTOR
JUMPEF
WIRE
Wire side of femal€ terminala
|G2 IALK/YELI
-
The ABS indicltor light doos
not go ofl aftor lhe engine is
3tartod.
-
With the SCS sorvico connoc
tor connoct d l.oe page 19371,
no DTC b indbat€d.
C h E C K t h E R E A F D E F R O S T E R
RELAY (7.5 A) fuse in the under-
dash fuse/relay box, and reinstall
the fuso if it is OK.
Roplaco tho tusa and rocheck.
Chock for an opcn GND circuit:
1. Connect the ABS control unit
22P connector terminal No. 1
to body ground with a jumper
2. Turn the ignition switch ON (ll).
. Ropair opon in tha wiro botwocn
tho ABS control unit and body
ground.
' Ropair poo. ground {G701 }.
Check for an open in thc lG2 ci.-
cuit:
Measure the voltage botween the
ABS control unit 22P connector
terminal No. 11 and body ground.
Roprir opon in thc wira bdtwoen
t h o R E A R O E F R O S T E R R E L A Y
17.5 Al fu$ end th. ABS control
unit.
ls th6re battery voltage?
Check the ABS contJol unit:
Connect the ABS control unit 12P
connector terminal No. 1 to body
ground with a jumper wire.
Chock for looao ABS control unh
conncctoas, It nacas3aly, sub3ti-
tuto a known-good ABS control
unit and r.check.
(To page 19-43)
19-42