Table of Contents
Advertisement
Dashboard
Component Removal/lnstallation (cont'dl
5.
Remove the knee bolster.
: Bolt
A
' i r
l o c a t i o n s , 3
6 x 1 . 0 m m
9 . 8 N . m
{ 1 . 0 k g t m ,
7.2 tbf.fit
0
6. lnstallation is the reverse o{ the removal procedure.
Ste.eo ladio/cassette, Heatet contlol Danel removal:
1. Remove the rear console, then remove the front
console (see page 20-130).
Loosen the bolts, then remove the stereo radio/
cassette by pulling it out.
Disconnect the connector and antenna lead.
NOTEr The original radio has a coded theft protec-
tion circuit. Be sure to get the customer's code num-
ber before
- disconnecting the battery.
-
removing the No. 47 (7.5 A) tuse from the under-
hood fuse/relay box.
-
removing the radio,
After service, reconnect power to the radio and turn
it on. When the word
"CODE" is displayed, enter
the customer's 5-digit code to restore radio
ope.ation.
KNEE BOLSTER
20-134
CONNECTOR
CASSETTE
: Bolt locations, 2
6 x 1 . 0 m m
9 . 8 N . m { 1 . 0 k g t m ,
3. Carefully pry the hazard warning switch and rear
window detogger switch out of the heater control
p a n e l .
Disconnect the connectors.
HAZARD WARNING
swtTcH
REAR WINDOW
DEFOGGER SWITCH
CONNECTORS
Advertisement
Table of Contents
Troubleshooting
