Table of Contents
Advertisement
J
Tapered Roller Bearing Preload Adjustment
l f a n y o f t h e i t e m s l i s t e d b e l o w w e r e r e p l a c e d , t h e
tapered roller bearing preload must be adjusted,
. Transmission housing
. Clutch housing
.
Limited slip diffsrential assembly
. Tapored roller bearing and bearing outer race
. Thrust shim
. 7 9 , 5 m m s h i m
Remove the bearing outer race, the thrust shim, and
the 79,5 mm shim from the transmission housing.
R e p l a c e t h e t h r u s t s h i m a n d t h e 7 9 . 5 m m s h i m i f
they were dsmaged when the bearing outer race
was driven out.
F i r s t t r y t h e s a m e s i z e 7 9 . 5 m m s h i m t h a t w a s
removeo.
HOUSING
Install the thrust shim and only one 79.5 mm shim
in the transmission housing, then drive in the bear-
Ing our€r race.
Noto these items during rassembly:
. Install the bearing outer race squarely.
. Check that there is no clearance between the
b e a r i n g o u t e r r a c e , s h i m s a n d t r a n s m i s s i o n
housing,
W i t h t h e m a i n s h a t t a n d c o u n t e r s h a f t r e m o v e d ,
installthe differential assemblv. Assemble the clutch
housing and transmission housing without a sealing
a9ent, and torque the case bolts.
8 x 1.25 mm
27 N.m (2.8 kgf.m, 20 lM.ft)
Rotate the differential assemblv in both directions
to seat the tapered roller bearings.
Measur€ the tapered roller bearing preload of the dif-
ferential assembly in both directions with the special
tool and a toroue wrench.
STANDARD: 2.11 - 3.04 N.m
(2!.5 - 31.0 kgt'cm,
18.7 - 26.9 lbf.in)
PNELOAD INSPECTION TOOL
07TAJ - ST701dt
(cont'd)
15-25
Advertisement
Table of Contents
Troubleshooting
