Table of Contents
Advertisement
Adjustment
NOTE:
. Before adjusting the hatch, loosen each bolt and nut slightly.
. Do not installthe support struts.
1. Adjust the hatch hinges rightand left, aswell asforeand aft. byusing the elongated holes.
2. Turn the hatch edge cushions, as necessary, to make the hatch fit flush with the body at each side.
3. Adjust the hstch fit to the hatch opening by moving the striker.
4. Use shims. as necessary, to make the hatch fit flush with the body at the rear edge.
5. Adiust the hatch side stop so that there is no clearance between it and the body side stop, then tighten the mounting
bolt (Tvpe R).
HATCH
EDGE CUSHION
STOP
(Typ. R
Modoll
SIDE
STOP
lTyp. R
Modell
HATCH
EDGE
CUSHION
stoE
STRIKER
HATCH
EDGE CUSHION
Type R Model:
SIDE STOP
(Hatch side)
SIDE STOP
(Body side)
6 x l , 0 m f t
9.8 N.m 11.0 kg{.m,
7.2 tbf.ftl
6 x 1 . 0 m m
9.8 N.m (1.0 kgt m,
?.2 tbf.ftl
SIDE STOP
(Hatch side)
Adjust for
no clearance,
SIDE STOP
(Body side)
NOTE: Move the striker right or left until it's centered
in the hatch latch as shown.
STRIKER
HATCH
8 x 1.25 mm
SHIM
8 x 1.25 mm
22 N.m 12.2 kgl.m,
16 rbt.ft)
HATCH
Advertisement
Table of Contents
Troubleshooting
