Table of Contents
Advertisement
Power Steering Gearbox
Disassembly (cont'dl
VINYL TAPE
1 2 m m
FLANGE NUT
13. Set the gearbox in a press so the gearbox housing
pornts upward.
14. Install the flange bolt into the end of the steering
r a c k u n t i l i t b o t t o m s i n t h e h o l e , t h e n b a c k t h e
f l a n g e b o l t o u t 1 / 4 t u r n . H o l d t h e f l a n g e b o l t a n d
tighten the flange nut against the rack by hand.
15. Press the cylinder end seal and steering rack out of
the gearbox.
NOTE: Hold the steering rack to keep it from falling
when pressed clear.
T-
I
I
170 mm
CYLINDER
END SEAL
Remove the flange bolt and cylinder end seal from
the steering rack.
Press
t
1 8 .
1 7 .
Ple3s
I
ATTACHMENT, 23 x 25 mm
07NAD - SR3020A
CYLINDER END
SEAL
19. Carefully pry the piston seal ring and O-ring off the
oiston of the rack.
CAUTION: Be carelul not to damage the inside of
seal ring groove when remoying the seal ring.
lnsert a 24" long, 3/8" drive extensjon, and the spe-
cial tool into the cylinder from the gearbox side.
CAUTION: Be careful not to damage the inside sur-
lace of the housing with the lools.
Set the gearbox in a press, then press out the cylin-
der end seal and backup ring from the gearbox.
CAUTION:
. Keep the tool straight to avoid damaging the
cylinder wall, Chcck thc tool angle, and correct il
necessary, when removing the cylinder end s€al.
. Use a press to remove the cylinder end seal. Do
not try to remove the seal by striking the tool. lt
will brcak the backup ring and the cylinder end
seal will remain in the gesrbox.
Replace
17-46
Advertisement
Table of Contents
Troubleshooting
