Table of Contents
Advertisement
J
)
I
4 .
2 .
1 .
5 .
Remove the antsnna mast (see page 23-2031.
Remove the antenna tubs/motor assembly (see page
23-2031.
Remove the tube clamping screw, and pull the an-
tenna tube out of the motor.
Remove the plastic guide and plastic insulator tube,
and install them in the new antenna tube.
CONNECTOR
HOLDER
PLASTIC
INSULATOR
TUAE
PLASTIC
GUIOE
lnsert the new antenna tube.
With an alignm6nt ma.k:
- Insert the new antenna tube into the motor, and
align the mark on the tube with the screw that
is used to clamp the tube to the motor,
Without an alignmont markr
- Insen onlv the tube, and install the tube/motor
assemblv in the car.
- Adjust the tube so that the collar lits properly
against the body. and mark the tube and motor.
- Remove the tube/motor assembly again.
- Align the mark on the tube with the mark on the
motor, and tighten the clamping screw.
With an alignmant m!*:
ALIGNMENT
MARK
CLAMPING
SCREW
Wilhout an allgnmont hark:
ADJUST THE
SO THAT THE
COLLAR FITS THE
CONTOUB OF THE
BODY.
WHEN THE ALIGNMENT
IS CORRECT, MARK
TUBE AND MOTOR.
o .
7 .
Install the tub6/motor assembly in th€ car (see page
23-203t.
Insert th€ mast into ths tube (see page 23-204).
23-205
Advertisement
Table of Contents
Troubleshooting
