Table of Contents
Advertisement
Remove the vinyl tape from the steering rack, then
push in the cylinder end seal with your finger.
NOTE:
. Remove any resideue of tape adhesive.
. T a k e c a r e n o t t o d a m a g e t h e c y l i n d e r e n d s e a l
with the threads and burrs at the staked position
of the gearbox.
I n s t a l l a p u l l e r y o k e t o t h e s t e e r i n g g e a r b o x , t h e n
c l a m p t h e p u l l e r y o k e i n a v i s e w j t h s o f t j a w s a s
shown.
PULLER YOKEI
{Commcrci.lly .vailablel
Sn.p-On@ T/N c.r123-1
oTc€ T/N 7372
or equivalent
Grease the inside surface of the cylinder end. then
install the cylinder end by screwing it into the cylin
d e r ,
After tightening the cylinder end, stake the point of
the cylinder housing shown below.
NOTE: Stake in the cylinder in the position opposite
from where the stake was removed during disas-
semory.
Stake point. Dopth: 1.0 mm (0.04 inl
4.0 mm (0.16 inl
CYLINOER END
46.
\
4 7 .
49.
coat the new o-ring with grease and install it in the
groove in the gearbox housing.
Apply grease to the needle bearing in the gearbox
h o u s i n g .
Install the valve body unit on the gearbox housing
by engaging the gears. Tighten the flange bolts to
the specified torque.
NOTE: Note the valve body unit installation posi-
tion (direction of pipe connection).
VALVE BODY UNIT
(cont'd)
O.RING
Replace.
-611
NEEDLE AEARING
-Grl
1 7 - 5 5
Advertisement
Table of Contents
Troubleshooting
