Table of Contents
Advertisement
Driveshafts
LEFT INBOARD JOINT
DYNAMIC DAMPER
Reassembly
NOTE:
. Clean the disassembled parts with solvent, and dry them thoroughly with compressed air. Do not wash the rubber
parts with solvent.
o -@l
: Thoroughly pack the inboard joint and both joint boots with the joints boots with the joint grease included
in the new driveshaft set.
Grease quantity:
lnboard Joint
Alf models: 120 - 130 g l1-2 - 1.6 ozl
Outboard Joint
USA model: 90 - 100 S 13.2 - 3.5 oz)
Canada model: 105 - 115 g {3.7 - 4.1 ozl
. The Canada model uses a TPE (Thermoplastic Polyester Elastomer) outboard joint boot. Use the ear clamp type boot
band in the outboard joint boot set.
SET RING
Replace.
INBOARD BOOT
-#,1
Pack cavity with grease.
Pack cavity with grease.
OUTEOARD BOOT
with grease''
OOUBLE LOOP BANDS
Replace.
OUTBOARD JOINT
C a n a d a m o d e l
o u t b o a r d j o i n t o n l y .
l
-6{
Pack cavity
INBOARD JOINT
DRIVESHAFT
1 6 - 8
OUTBOARD
wrln grease,
Advertisement
Table of Contents
Troubleshooting
