Acura Integra 1998 Service Manual page 1380

SRS Unit
Replacement
CAUNON:
. Betore disconnecting the SRS main harness 18P con-
nector, disconnect the aitbag connectors.
. During installation or replacement, do not bump
(impact wrench, hammer etc.) the al€a near the SRS
unit.
. Do not damage the SRS unit terminals or connec-
tors.
. Do not disassemble the SRS unit; it has no service-
able parts.
. Store the SRS unit in a clean, dry area.
. Do not use any SRS unit which has been subiected
to water damage or shows signs of being dtopped ol
improperly hsndled, such as dents, cracks or detor-
mation.
Disconnect the baftery negative cable, then discon-
nect the positive cable from the battery, and wait at
least three minutes.
Disconnect the airbag connectors. (When discon-
n e c t e d . t h e a i r b a g c o n n e c t o r s a r e a u t o m a t i c a l l y
shorted.)
Driver's Side:
. R e m o v e t h e a c c e s s p a n e l f r o m t h e s t e e r i n g
w h e e l , t h e n d i s c o n n e c t t h e 2 P c o n n e c t o r
between the driver's airbag and cable reel (see
page 23-285).
Front Passenger's Side:
. Disconnect the 2P connector between the front
passenger's airbag and SRS main harness (see
page 23-285).
3.
Remove the right side cover from the SRS unit.
SRS UNIT
TORX
BOLTS
Use a Torx
T30 bir.
SIDE
covEn
4.
Remove the left side cover from the SRS unit, then
d i s c o n n e c t t h e S R S m a i n h a r n e s s 1 8 P c o n n e c t o r
from the SRS unit.
sRs
HARNESS
18P CONNECTOR
t
TORX
BOLTS
U36 a Toax
T30 bh.
SIDE
COVER
Remove the four Torx bolts from the SRS unit, then
pull out the SRS unit from the driver's side.
23-326
? \
SRS UNIT