Table of Contents
Advertisement
Countershaft
Disassembly/Reassembly
(cont'dl
3. Install the reverse selector hub on the countershaft
sub-assembly, and then press the reverse selector
hub using the special tool and a press as shown.
Clearance Measurement
NOTEr Lubricate all parts with ATF during assembly.
1. Remove the countershaft bearing from the transmis
s i o n h o u s i n g ( s e e p a g e 1 4 1 5 6 ) .
2. lnstallthe parts below on the countershaft using the
special tool and a press as described on this page.
NOTE: Do not assemble the O-rings during an-
s p e c t i o n .
REVERSE SELECTOR
HUB
4TH GEAR
BEARING
DISTANCE COLLAR, 28 mm
Selective part.
2ND GEAR
THRUST NEEDLE BEARING
3RO GEAR
THRUST NEEDLE BEARING
SPLINED WASHER
BEARING
GEAR COLLAR
CLUTCH ASSEMBLY
14-138
Advertisement
Table of Contents
Troubleshooting
