Acura Integra 1998 Service Manual page 1372

Airbag
Replacement (cont'd)
LOWER
MOUNTING
NUTS
Fror|t P..s6nger'r Side:
. Remove the tour mounting nuts from the bracket.
. Lift the front passenger's airbag out of the dashboard
by covering the lid and dashboard with a cloth. and
prying carefully with a flat-tip screwdriver.
N O T E : T h e l i d o f t h e a i r b a g h a s p a w t s o n i t s s i d e
which attach it to the dashboard.
CAUTION: Be sure to install the SRS wiring so that it is
not pincbed or interfering with other parts.
5. Install the new airbag(s):
Driver's Side: Place the driver's airbag into the steering
wheel. and secure it with new Torx bolts.
TORX BOLT
9.8 N.m 11.0 kgf.m, 7.2 tbf.ft)
TORX BOLT
9.8 N.m lt.o kgt m,
7.2lbf,ftl Reptace.
U36 a Torx T30 bit.
Front Paseenge/s Side:
P l a c e t h e f r o n t p a s s e n g e r ' s a i r b a g i n t o t h e d a s h ,
bosrd.
Loosely install all four mounting nuts.
Tighten the upper two nuts first, then tighten the
lower two nuts. Adjust the lower mounting bracket if
necessarv.
a
a
MOUNTING NUTS
9.8 N.m (1.0 kgf.m. 7.2 lb{.ftl
Replace.
Us€ a Torx T30 bit.
MOUNTING NUTS