Table of Contents
Advertisement
Evaporator
Replacement
Cut the dashboard insulato. at the areas shown.
Disconnect the connector from the A,,/C thermostat.
and remove the wire harness clips from the evapo-
rator.
6 x 1.0 rnm
9.8 N.m 11.0 kgf.m,
7.2 tbl.ft)
EVAPOBATOB
7.
Remove the four self-tapping screws. the mounting
bolt and the mounting nut.
8.
Disconnect the drain hose, and remove the evapo-
rator.
9,
Install in the reverse order of removal, and:
. if you're installing a new evaporator, add refrig-
erant oil (ND-OlL 8: PiN 38897 - PR7 - A0IAH or
38899 - PR7 - A0 I I lsee page 22-21) .
. replace the O-rings with new ones at each fitting,
a n d a p p l y a t h i n c o a t o f r e f r i g e r a n t o i l b e f o r e
installing them.
NOTE: Be sure to use the right O-rings tor HFC-
134a (R-134a) to avoid leakage.
. apply sealant to the grommets.
. make sure that there is no air leakage.
. charge the system (see page 22-39) and test its
performance {see page 22-24l.
CLIPS
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section {23) before performing repairs or ser-
vice.
1. Recover the retrigerant with a Recovery/Recycling/
Charging System \see page 22-221.
2.
Remove the bolts, and disconnect the receiver line
and the suction line from the evaporator.
NOTE: Plug or cap the lines immediately after dis-
connecting to avoid moisture and dust contamina-
U O n .
6 x 1 . 0 m m
9.8 N.m 11.0 kgf.m,
1.2 tbi.ft)
Remove the glove box (see section 20).
Remove the four bolts and the glove box frame.
4.
SUCTION LINE
RECEIVER LINE
22-26
Advertisement
Table of Contents
Troubleshooting
