Acura Integra 1998 Service Manual page 1284

Integra 1998
Hide thumbs Also See for Integra 1998:
Table of Contents

Advertisement

)
Function Test
NOTE: To test, remove the driver's door panel (see sec-
tion 20), then disconnect all of the connectors from the
ooor panet.
Mifior Test
NOTE: Check the No. 17 {7.5 A) fuse in the under-dash
fuse/relay box before testing.
One or both inoperative:
Check for voltage between the BLK//EL terminal and
body ground with the ignition switch ON {ll).
There should be battery voltage.
. lf there is no voltage, check for:
* Blown No. 17 (7.5 A) fuse in the under-dash
fuse/relay box
- An open in the BLK/YEL wire
.
lf there is battery voltage, go to step 2.
Check for continuity between the BLK terminal and
body ground.
There should be continuity; check for.
* An open in the BLK wire
-
Poor ground (G501 (sedan), G502)
vrllBtxt YEL/RED'
aa*\
Left miror inoperative:
Connect the BLK,^/EL terminal of the 1OP connector to
t h e Y E V R E D 1 t e r m i n a l
a n d t h e Y E L / V H T ( o r Y E L / B L K 1 )
terminal to body ground with iumper wires.
The left mirror should tilt down (or swing left) when you
turn the ignition switch ON (ll).
a lf the mirror does not tilt down (or does not swing lett).
check for an open in the YEL/WHT {or YEL/BLKr}
wire between the left mirror and the switch. lf the wire
is OK, check the lett mirror actuaror.
a lf the mirror neither tilts down nor swings left, repair
the YEL/REDr wire between the letr mirror and the
swtlcn.
a lf the mirror operates properly, check the mirror
swttcn.
Right mirrol inoperative:
Connect the BLK/YEL terminal of the 10P connector to
the BLU,^/VHT terminal and the YELMHT {or BLU/BLK)
terminal to body ground with jumper wires.
The right mirror should tilt down (or swing left) when
you turn the ignition switch ON (ll).
a lf the mirror does not tilt down (or does not swing left),
remove the right door panel and check for an open in
the YEL/WHT (or BLU/BLK) wire between the right mir-
ror and the switch. lf the wire is OK, check the right
mirror actuator.
a lf the mirror neither tilts down nor swings lett, repair
the BLU/WHT wire between the right mirror and the
s w r t c h .
a lf the mirror operates properly, check the mirror
s w i t c h .
23-227

Advertisement

Table of Contents
loading

Table of Contents