Table of Contents
Advertisement
Hatch Latch and Lock Cylinder
Replacement
NOTE: Take care not to bend the cylinder rod and actua-
tor rod.
1 . R e m o v e t h e r e a r t r i m p a n e l ( s e e p a g e 2 0 - 9 2 1 .
2.
Disconnect the cylinder rod and each connector.
CONNECTOR
3.
Remove the bolts. then disconnect actuator rod.
Remove the hatch latch and actuator.
>: Screw loc6tion3
A > : 3
I > : 3
ACTUATOR
2 0 - 1 5 8
4.
Remove the lock cylinder by turning it 45".
>: Bolt location, 1
6 x 1 . o m m
I
9.8 N.m 11,0 kst m,
i
l.ztb$ft|
.)
lt: /
LOCK
CYLINDEB
Installation is the reverse of the removal procedure.
N O T E :
a Apply grease to the hatch latch
a
a
a
Make sure the hatch locks securely.
Make sure the hatch opens properly.
N4ake sure the connector is connected properlV.
Advertisement
Table of Contents
Troubleshooting
