Acura Integra 1998 Service Manual page 901

Moonroof
Rear Edge Closing Adjustment
Open the glass about a foot, then close it to check where
rear edge begins to rise. l,f it rises too soon and seats too
tightly against the root panel, or too late and does not
seat tightly enough, adjust it.
1 . R e m o v e t h e h e a d l i n e r ( s e e p a g e 2 0 - 1 O 0 ) .
2 . R e m o v e t h e g l a s s .
3 . R e m o v e t h e m o t o r ( s e e p a g e 2 0 ' 8 7 ) .
4.
Align the tilt-up position of the lifter on each side.
Check that the alignment left and right, then install
the motor.
Install the glass, then check for water leaks.
NOTE: Do not use high-pressure water.
l n s t a l l t h e h e a d l i n e r .
20-86
Glass and Sunshade RePlacement
1 . O p e n t h e s u n s h a d e .
2 . T i l t - u p t h e g l a s s .
3. Remove the bolts, then remove the glass lrom the
glass bracket.
Use the moonroof
GLASS ERACKET
Remove the screws and lift the sunshade rails
Silde the sunshade forward, then remove the
sunsnaqe.
SUNSHADE
RAIL
lnstallation is the reverse ofthe removal procedure.
Check for water leaks.
NOTE: Do not use high-pressure water.
9 . 8 N m ( 1 . 0 k g l m ,
6 .
7 .