Table of Contents
Advertisement
' 1 .
When reassembling the distributor, install the rotor
on the shatt so that it faces an the direction shown
( t o w a r d t h e N o . 1 c v l i n d e r ) .
2 .
Align the index mark on rhe distributor ignition (Dl)
housing with the index mark on the end of the shaft.
INDEX MARKS
Distributor Reassembly
lgnition Wire Inspection and Test
J
J
)
23-95
CAUTION: Carelully remove the ignition wires by pull-
ing on the rubber boots. Do not bend the wires; you might
break them inside.
'1 .
Check the condition ot the wire terminals. lJ any ter-
minal is corroded, clean it, and if it is broken or dis-
torted. reolace the wire.
Check for broken,
corroded, and bent
terminals.
IGNITION WIRE
Connect ohmmeter probes and measure resistance.
lgnition Wire Resistance:
25 kO max. at 68oF {20oC}
IGNITION WIRE
3. It resistance exceeds 25 k0, replace the ignition wire.
) l -
Advertisement
Table of Contents
Troubleshooting
