Table of Contents
Advertisement
Steering Golumn
Removal
I
a All SRS wire harnesses are covered with yellow insu-
lation. Before vou disconnect any pan of an SRS wire
harness, disconnect the airbag Gonnectors.
a Whenever the ignition switch is ON (lll, or has been
turned OFF for less than three minutes, be carelul not
to bump the SRS unit; the airbags could accidentally
deploy and cause damage or iniuries.
a For additional precautions, lelel to the SRS sub-section
in section 23.
1 . R e m o v e t h e a i r b a g a s s e m b l y a n d s t e e r i n g w h e e l
(see page 17-25).
2.
Remove the lower cover.
3.
Remove the driver's knee bolster,
R e m o v e t h e c o l u m n c o v e r s b y r e m o v i n g t h e
screws.
' / /
,,1G
LOWER COVER
1 7 - 28
1 .
9 .
Remove the SRS wire harness connector from the
connector holder.
Disconnect the cable reel connector and SRS main
wire harness connector (see page 17-24).
CONNECTOR HOI-DER
SRS WIRE HARNESS CONNECTOR
Disconnect the cruse control switch connector from
the cable reel, and remove the cable reel trom the
combination switch.
Remove the turn signal canceling sleeve.
Remove the combination switch from the steering
column by disconnecting the connectors.
Advertisement
Table of Contents
Troubleshooting
