Transmission
SUB.SHAFT
M A I N S H A F T
Reassembly {cont'd)
27. lnstallthe specialtool onto the mainshaft as shown.
Install the parking brake lever on the control shaft.
Assemble the one-way clutch and the parking gear
with the countershaft 1st gear (see page 14-141),
Install the countershaft 1st gear collar. needle bear-
i n g a n d t h e c o u n t e r s h a f t 1 s t g e a r / p a r k i n g g e a r
assembly on the countershaft.
I n s t a l l t h e p a r k i n g b r a k e p a w l s h a f t , s p r i n g , p a w l
a n d p a w l s t o p o n t h e t r a n s m i s s i o n h o u s i n g . t h e n
e n g a g e t h e p a r k i n g b r a k e p a w l w i t h t h e p a r k i n g
9ear.
PARKING GEAR
28.
3 1 .
I
I
i
I
BRAKE
LEVER
CONTROL SHAFT
1ST CLUTCH
COUNTERSHAFT
|
14-164
32, Install the old conical spring washer and locknut on
the countershaft. Tighten the old locknut to seat the
parking gear to the speciJied torque, then remove
t h e m .
NOTE:
. Do not use an impact wrench, always use a torque
wrench to tighten the locknut.
. Countershaft locknut has left-hand threads,
TOROUE: to3 N.m (10.5 kgf'm, 75.9 lbl.ft)
PARKING GEAR
Install the sub-shaft 1st gear on the sub-shaft.
I n s t a l l t h e m a i n s h a f t 1 s t g e a r c o l l a r o n t h e m a i n -
shaft.
Wrap the mainshaft splines with tape to prevent
damage the O-rings, then install new O-rings on the
mainshaft,
Assemble the thrust washer, thrust needle bearing,
needle bearing and mainshaft lst gear on the 1st
clutch assembly, then installthem on the mainshaft.
34.