Table of Contents
Advertisement
u
1 9 .Remove the right front mount/bracket, then remove
the end of the throltle control cable from the throt-
t l e c o n t r o l d r u m .
R e m o v e t h e A T F c o o l e r h o s e s a t t h e A T F c o o l e r
lines. Turn the ends of the cooler hoses up to pre-
vent ATF from flowing out, then plug the ATF cooler
lines.
NOTE: Check for any sign ol leakage at the hose
j o r n r s .
THROTTLE CONTROL CABLE
2 0 .
f
RIGHT FRONT MOUNT/BRACKET
21. Remove the engine stiftener and torque converter
cover,
22. Remove the eight drive plate bolts one at a time while
rotating the crankshaft pulley.
EOLTS
ATF COOLER
Replace. HOSES
ENGINE
STIFFENER
COVER
TRA
14-107
23. Place a jack under the transmission. raise the trans-
mission just enough to take weight off of the
mounts, then remove the transmtssion mount.
TRANSMISSION MOUNT
24. Remove the transmission housing mounting bolts
and rear engine mounting bolts.
25. Pull the transmission away trom the engine until it
clears the 14 mm dowel pins, then lower it on the
transmission jack.
REAR ENGINE
MOUNTING BOLTS
Replace.
WASHERS
MISSION JACK
\
NS
Advertisement
Table of Contents
Troubleshooting
