Table of Contents
Advertisement
\
NOTE; Wash the knuckle and hub thoroughly in high
flash point solvent before reassembly.
5.
Press a new wheel bearing into the knuckle using
the old bearing, a plate and a p.ess.
NOTE: Press the wheel bearing into the knuckle
with the pack seal (metal color) toward the inside. Be
careful not to damage the sleeve of the pack seal.
Installthe circlip securely in the knuckle groove.
SCREWS
5 x 0 . 8 m m
4.9 N'm (0.5 kgf.m,3.5lbtftl
SPLASH GUARO
7.
Install the splash guard and tighten the screws.
1 8 - 1 5
Installthe front hub on the knuckle using the special
tools and a press as shown,
CAUTION: Tako csro not to distort tho splash guard.
pre3s
DRIVER
I
0??a9 - 0010000
v
ATTACHMENT,
6 2 x 6 8 m m
07746 - 00t0500
SPLASH GUARD
KNUCKLE
FRONT HUB
{cont'd)
Advertisement
Table of Contents
Troubleshooting
