Table of Contents
Advertisement
Power Steering Gearbox
Reassembly (cont'dl
Installthe cylinder lines A and B.
NOTE:
. Clean the joints of the cylinder line A and B thor-
oughly. The joints must be free ol foreign materi-
a t .
.
Install the cylinder line A and B by tightening the
flar€ nuts by hand first, then tighten the flare
nuts to the specified torque staning with the
cylinder side nuts.
CYLINDER I-INE B
26 N.m {2.7 kgf.m, m lbl.ftl
50.
5 t .
Grease the sliding surface of the rack guide
install it onto the gearbox housing,
a n d
52.
53.
LOCKNUT
q
SPRING
RACK GUIDE SCREW
Install the spring, rack guide screw and locknut on
the gearbox housing.
Adjust the rack guide screw (see page 17-2'll,
NOTE: After adiusting, check that the rack moves
smoothly by sliding to rack right and left.
17-56
STEERING RACK
WOODEN BLOCK
54. Install the new lock washer in the groove in the
steering rack.
Screw each rack end into the rack.
Hold the left end of the steering rack with I wrench
and tighten to th€ rack ends with another.
56.
After tightening the rack end, stake the four sections
of lock washer with a commerciallv available roll
pin drift and a mallet.
RACK END
5{ l{.m
{5.5 kgl.m, aO lbt.ftl
ROLL PIN DRIFT
lcomm.rci.lly .v.ihbl.l
(Sn.pon f{o, PPR8 or .quiv.lc.n}
LOCK WASHER
Replace.
NOTE: This dritt has a
to prevent puncturing
ot metal washer.
Advertisement
Table of Contents
Troubleshooting
