Acura Integra 1998 Service Manual page 378

Reverse Change Holder,
Clearance Inspection {cont'dl
Reverse ldler Gear
Removal
1. Remove the reverse change holder.
2.
Remove the reverse idler gear and the reverse idler
oear shaft.
\
i 1
\
Measure the clearance between the reverse idler
gear and the reverse change holder,
Standard:
0.5 - 1.1 mm (0.02 - 0.04 in)
Sorvice Limit: 1.8 mm (0,07 inl
4 .
lf the clearance is more than the service limit, mea-
sure the width of the reverse change holder.
Standa;d: 13.0 - 13.3 mm (0.512 - 0.524 inl
lf the width is not within the standard, reDlace
the reverse change holder with a new one.
lf the width is within the standard, reDlace the
reverse idler gear with a new one.
REVERSE IDLER GEAR
REVERSE CHANGE HOLDER
REVERSE CHANGE HOLDER
REVERSE CHANGE HOLDER
\