Table of Contents
Advertisement
8 .
9 .
f;:Y:fffrf#:J'uer'
Sl[
Measure the clearance between the reverse change
holder and the sth/reverse shift piece pin.
Standard:
Reverse Side: 0.05 - 0.45 mm (0.002 - 0.018 inl
5th Side:
0.4 - 0.9 mm (0.02 - 0.04 in)
Separate the transmission housing from the clutch
housing, and wipe it clean of the sealant.
R e m o v e t h e 7 2 m m t h r u s t s h i m a n d t h e o i l g u i d e
plate from the transmission housing
7 2 f i f i
THRUST SHIM
10. Remove the l6 mm sealing bolt and the oil gutter
plate.
OIL GUTT6R PLATE
lf the clearance are not within the standard, mea-
sure the width of the grooves in the reverse change
holder.
Standard:
Revsrse Side: 7.05 - 7.25 mm {0.278 - 0.285 in)
5th Side:
7.4-7.7 mm (0.29 - 0.30 in)
REVERSE SIDE
lf the width of the grooves are not within the
standard, replace the rsverse change hbtder with
a new one.
lf the width of the grooves ar€ within the Stan
dard, replace the 9th/revense sHtFI piece wlth
new one.
(cont'
Advertisement
Table of Contents
Troubleshooting
