Release Bearing
lnstallation
With the release fork slid between the release bear-
ing pawls, install the release bearing on tha main-
shaft while inserting the release fork through the hole
i n t h e c l u t c h h o u s i n g .
RELEASE FORK BOLT
29 N.m (3.0 kgl.m,
22 tbt.ttl
Align the detent of the release fork with the release
fork bolt, then press the release fork over the release
fork bolt.
NOTE: Use only Super High Temp Urea Grease {P/N
o8798 - 9002).
Move the release fork right and l6ft to make sute that
the fork fits properly against the release bearing, 8nd
that the release bearing slides smoothly.
4.
lnstall the release fork boot.
-6
(P/N 08794-
-6
tPlN 08798-
RELEASE
12-12