Release Bearing
Removal/lnspection
1. Remove the release fork
h o u s r n g .
boot from the clutch
5 .
6 .
Torque the mounting bolts in a crisscross pattern as
shown. Tighten the bolts in several steps to prevent
warping the diaphragm spring.
8 x 1 . 2 5 m m
2 5 N . m { 2 . 6 k g f . m ,
19 tb{.fr}
Remove the special tools.
Recheck the diaphragm spring fingers for height {see
p a g e 1 2 - 7 ) .
CLUTCH HOUSING
BELEASE AEAFING
RELEASE FORK
Remove the release fork from the clutch housing by
squeezing the release fork set spring with pliers. Re
move the release bearing.
Check the release bearing for play by spinning it by
hand. lf there is excessive play, replace the release
bearing with a new one.
CAUTION: The release bearing is packed wirh
grease. Do not wash it in solvent.
a;;;:
S",€ r
K4IN/
RELEASE BEARING