Managing Val Announcements Using The Sat - Avaya Communication Manager Administrator's Manual

8. In the Port field, enter the cabinet location of the VAL board followed by port number 33.
Note:
Although the VAL board has only 32 ports, the data module uses 32 +1, or 33 for
Note:
its port value.
9. In the Link field, enter a communication interface link number between 1 and 99.
10. In the Name field, enter a name for the data module. Press Enter.
11. To ensure that the VAL board has been properly added, type status link n, where n is
the link number you assigned on the
of in-service/idle.

Managing VAL Announcements Using the SAT

These are the tasks that you can perform from a System Access Terminal (SAT):
Administering an announcement using the SAT
●
Recording announcements (with an option to use a system telephone)
●
Deleting announcements (with an option to use a system telephone)
●
To administer an announcement using the SAT, see
page 455.
Recording VAL announcements
You can record an announcement for callers to hear when they dial a specific extension or as
part of call vectoring. You can use the same steps to change an existing announcement.
You can record announcements in many ways:
Professional or computer recordings
●
Recording new announcements at a computer
●
Recording announcements at a system telephone
●
Before you start, ensure that the announcement administration is complete before proceeding.
You must have assigned a name before you can record an announcement (see
Announcement Extensions
If you are replacing a TN750C announcement circuit pack with the TN2501AP,
get a list and description of the announcements stored on the TN750C circuit pack.
●
re-record the announcements on a computer or at a professional recording studio as .wav
●
files (CCITT µ-Law or A-Law, 8KHz, 8-bit mono), so that they are ready to transfer to the
new announcement circuit pack after it is installed and administered.
Data Module
on page 455).
Managing VAL Announcements Using the SAT
screen. The link should display a status
Adding Announcement Extensions
Issue 1 June 2005
on
Adding
467