Avaya Communication Manager Administrator's Manual page 466

Managing Announcements
Task
Administering Announcements
(recording, copying, deleting, etc.)
Viewing announcement usage
measurements (list measurements
announcement command)
Troubleshooting announcements
Troubleshooting VAL hardware
Adding a TN2501AP VAL board
After a TN2501AP circuit pack is physically installed on your system, you must configure it in
Avaya Communication Manager.
To add a TN2501AP VAL board:
1. Type change node-names ip xxx. The system displays the
2. In the Name field, enter a name for the VAL board.
3. In the IP Address field, assign a valid IP address to the VAL board. Press Enter.
4. Type add ip-interface nnnnn, where nnnnn is the cabinet location of the VAL board.
The system displays the
5. Enter the appropriate information in the Node Name, Subnet Mask, Gateway IP Address,
and Network Region fields, and set the Enable Ethernet Pt field to y. Press Enter.
6. Type add data-module next. The system displays the
7. In the Type field, enter ethernet. The system displays the ethernet-specific fields.
466 Administrator Guide for Avaya Communication Manager
Information source
The G700 Media Gateway embedded VAL
also can be disabled using the disable
announcement-board ggV9 command.
This removes that gateway from the VAL
circuit pack count but announcements already
assigned and recorded/FTPed on that circuit
pack remain but will not play.
Managing VAL Announcements Using the
SAT on page 467 and
Announcements Using FTP
Reports for Avaya Communication Manager.
Troubleshooting VAL Announcements
page 480.
Maintenance Procedures for Avaya
Communication Manager for your model(s).
IP Interfaces screen.
Managing VAL
on page 473.
on
IP Node Names
Data Module screen.
2 of 2
screen.