Avaya Communication Manager Administrator's Manual page 849

CAPABILITIES
Busy Out
This option should be enabled for DTEs that are members of a hunt group and to allow "busy
out" when DTE turns power off so that calls do not terminate on that DTE.
Valid entries
y/n
Configuration
Appears when the KYBD Dialing field is y. This option normally is enabled for "originate/
receive" DTE such as non-intelligent terminals and disabled for intelligent devices such as
computers. The KYBD Dialing field must be y with this option.
Valid entries
y/n
KYBD Dialing
This option must be enabled to allow data endpoints to originate calls via the EIA 232C interface
and obtain ASCII feedback text. When enabled, the user gets the dial prompt. This option
normally is enabled for "originate/receive" DTE that has a need to set up data calls. If this option
is disabled, originations cannot be done at the DTE and text feedback does not occur at the
DTE during call setup/take down. Data call answering is still allowed but without text feedback.
Note:
ADU-type hunt groups connecting the system to terminal servers on a host
Note:
computer should have these hunt group extensions assigned as "no" keyboard
dialing.
Valid entries
y/n
Usage
Enter y to place the DLC port in a busied-out state once
the DTE control lead to the DLC is dropped.
Usage
Enter y to allow the viewing and changing of options
from the DTE.
Usage
Enter y to allow keyboard dialing. This enables the data
endpoint to receive and transmit text during call
origination or termination. Low must be n.
Data Module
Issue 1 June 2005 849