Avaya Communication Manager Administrator's Manual page 890

Screen Reference
Name
Use this field to assign a significant, descriptive name to the DS1 link. Avaya recommends
putting the vendor's circuit ID for the link in this field, because that information helps you
troubleshoot problems with the link, but you could also use this field to indicate the function or
the destination of this DS1 facility. In that case, put the DS1 link circuit ID in the Name field of
the trunk group associated with this link.
Valid entries
1 to 15
characters
Peer Protocol
This allows you to administer the peer level protocol that will operate in a private network. This
field appears if the Interface field is peer-master or peer-slave. To enter Q-SIG, the Basic
Call Setup field on the System-Parameters Customer-Options screen must be y
.
Valid entries
Q-SIG
TTC
Protocol Version
In countries whose public networks allow multiple layer-3 signaling protocols for ISDN-PRI
service, this field selects the protocol that matches your network service provider's protocol.
See Public network signaling administration for ISDN-PRI Layer 3
countries support which protocols.
This field appears only when:
The Signaling Mode field is isdn-pri and the Connect field is network.
●
The Signaling Mode field is isdn-pri, the Connect field is pbx, and the Interface field is
●
user or network.
.
Valid entries
a, b, c, d
890 Administrator Guide for Avaya Communication Manager
Usage
Enter a name for the DS1 link.
Usage
This implements QSIG Network Basic Call.
For private networking. Requires a Digital Trunk (Japan
2 MB TTC) (TN2242) circuit pack.
Usage
The entry in this field must match the protocol used by
your network service provider, so work with your vendor
to determine the appropriate entry.
on page 891 to see which