Avaya Communication Manager Administrator's Manual page 471

Deleting all VAL announcements on a circuit pack using the SAT
To delete all of the announcement files on the VAL circuit pack:
1. At the SAT, type busyout board board-location and press Enter.
Ensure that the command is successful.
Note:
When the VAL board is busied out,
Note:
both the RSCL and ethernet ports are busied out.
●
firmware takes down the ethernet link.
●
FTP is disabled because the ethernet link is down.
●
announcements on that circuit pack cannot play.
●
2. At the SAT, type erase announcements board board-location and press Enter.
!
CAUTION:
This command deletes the specified announcement file in both RAM and FLASH
CAUTION:
memory. The board firmware ignores the protect flag (Pro field) when erasing the
announcement files.
3. For a VVAL, type list directory board nnnnn, where nnnnn is the board location, to
display the announcements directory. For a TN2501AP VAL board, type list directory
board nnnnn/annc (adding the /annc extension) to reach the announcement directory.
Press Enter.
4. Verify that there are no files listed.
5. Type list integrated-annc-boards and press Enter.
Check the list to see that the announcement was deleted. The Length in Seconds field
should show 0.
Deleting VAL announcements at a system telephone
See Deleting and Erasing Announcements.
Managing VAL Announcements Using the SAT
Issue 1 June 2005 471