Avaya Communication Manager Administrator's Manual page 349

The MM parameter selection FAC may be used in conjunction with the mm-multinbr button
or FAC to make a single or dual address multimedia call at the desired bearer and
bandwidth. The user goes off-hook and dials the MM-parameter selection feature access
code. Dialtone is returned. The user enters a single digit, 1 or 2, where 1 = 2x64, 2 = 2x56.
All other digits will produce reorder. Dialtone is returned. Upon dialing of the MM-parameter
selection FAC, the mm-call (if present) status lamp (green led) should become solid. The
user may indicate a dual-address call at this point with the mm-multinbr button or FAC. The
user now dials one or two sets of destination address digits. The destination address may
be provided by dialing digits, using abbreviated dial entries, last number dialed, etc.
Note:
The mm-parameter selection FAC is generally used by stations that are part of an
Note:
Enhanced multimedia complex, but may be used by any station to originate a
dual address multimedia call.
6. Dialing sequences that include TACs, AAR, ARS, Authorization codes, CDR account
codes, FRLs
1. Single address with TAC
Dial mm-call button or FAC, Hear dialtone
●
Dial TAC, Dial destination digits
●
2. Dual address with TAC
Dial mm-multinbr button or FAC, Hear dialtone
●
Dial TAC, Dial 1st dest. digits, Hear dialtone
●
Dial TAC, Dial 2nd dest. digits
●
3. Single address with AAR/ARS
Dial mm-call button or FAC, Hear dialtone
●
Dial AAR/ARS, Dial destination digits
●
4. Dual address with AAR/ARS
Dial mm-multinbr button or FAC, Hear dialtone
●
Dial AAR/ARS, Dial 1st dest. digits, Hear dialtone
●
Dial AAR/ARS, Dial 2nd dest. digits
●
5. Single address with AAR/ARS and authorization code
Dial mm-call button or FAC, Hear dialtone
●
Dial AAR/ARS FAC, Dial destination digits, Hear stutter dialtone
●
Dial authorization code
●
Enhanced Mode MM Complex
Issue 1 June 2005 349