Avaya Communication Manager Administrator's Manual page 507

Depending on the hardware used, assign ports to the following:
Data modules
●
7400D-series or CALLMASTER digital telephones
●
7500D-series telephones with asynchronous data module (ADM)
●
Analog modems (port is assigned using 2500 telephone screen)
●
Characters used in Data Call Setup
Basic-digit dialing is provided through an ADM or 7500B data module. The user can enter digits
from 0 to 9, *, and # from a 7500 or 8500 series telephone keypad or an EIA-terminal interface.
In addition, the user can dial the following special characters.
Table 5: Special characters
Character
SPACE, -, (, and)
+ character (wait)
, (pause)
% (mark)
UNDERLINE or
BACKSPACE
@
Each line of dialing information can contain up to 42 characters (the + and % characters count
as two each).
Examples of dialing are:
DIAL: 3478
●
DIAL: 9+(201) 555-1212
●
DIAL: 8, 555-2368
●
DIAL: 9+555-2368+%9999+123 (remote access)
●
Use
improves legibility. Communication Manager
ignores these characters during dialing.
interrupts or suspends dialing until the user
receives dial tone
inserts a 1.5-second pause
indicates digits for end-to-end signaling
(touch-tone). This is required when the trunk
is rotary. It is not required when the trunk is
touch-tone.
corrects previously typed characters on the
same line
deletes the entire line and starts over with a
new DIAL: prompt
Data Call Setup
Issue 1 June 2005 507