Avaya Communication Manager Administrator's Manual page 595

Figure 221: Trunk Group screen
Group Number: 3
Group Name: DIOD_PPM___________________ COR: 1_
Direction: two-way_
Dial Access? n
Queue Length: 0__
Comm Type: voice
Prefix-1? y
TRUNK PARAMETERS
Outgoing Dial Type: tone
Trunk Termination: rc
Digit Treatment:
Expected Digits:
Disconnect Supervision - In? y
Answer Supervision Timeout: 0__
2. In the CDR Reports field, type y.
This ensures that the PPM information appears on the CDR report.
3. In the Direction field, type two-way.
4. In the PPM field, type y.
5. In the Frequency field, type 50/12.
This is the signal frequency (in kHz). The frequency you will use depends on what the circuit
pack you use is able to accept. See
6. In the Administrable Timers section, set the Outgoing Glare Guard timer to 5 seconds.
7. Press Enter to save your changes.
8. You also need to ensure that the values of the Digital Metering Pulse Minimum,
Maximum and Value on the DS1 Circuit Pack screen are appropriate to the values offered
by your service provider. See
Related topics
For more information about AOC and PPM, see "Call Charge Information" in Feature
Description and Implementation for Avaya Communication Manager, 555-245-205.
TRUNK GROUP
Outgoing Display? n
Busy Threshold: 99_
Trunk Type: auto/immed
Trunk Gain: high
DS1 Circuit Pack
Group Type: diod
Auth Code? n Digit Absorption List:
Trunk Flash? n
Incoming Dial Type: tone
Sig Bit Inversion: none
Out? n
Recieve Answer Supervision: y
Tone Generation on page 1530 for more information.
on page 879 for more information.
Receiving Call-Charge Information
Page 1 of x
CDR Reports: y
TN: 1__ TAC: 112_
Night Service: ________
Toll Restricted? y
Digits:
Drop Treatment: silence
Issue 1 June 2005 595