Avaya Communication Manager Administrator's Manual page 581

5. In the Re-enter Password field, repeat the new password.
Note:
If these password fields are not administered correctly, all SNMP requests to the
Note:
CMSA will fail..
6. In the SNMP Version 1 section, check the Enable SNMP Version 1 box if SNMP Version 1
is needed.
This is the SNMP version of the protocol to be used in communicating with the CMSAs on
the server.
Note:
The Community Name fields are the authentication mechanism for SNMP v1
Note:
and v2c. The name can contain up to 50 characters. Any character can be used
except ". There must be no spaces and the text is case sensitive.
7. In the Community Name(read-only) field, type the name.
8. In the Community Name(read-write) field, type the name.
The user can query agents for information (SNMP GETSs) and send commands to an
agent (SNMP SETs).
9. In the SNMP version 2c section, check the Enable SNMP Version 2c box if SNMP Version
2 is needed.
10. In the Community Name (read-only) field, type the name.
11. In the Community Name (read-write) field, type the name.
12. Scroll down to the SNMP Version 3 section and check the Enable SNMP Version 3 box if
SNMP Version 3 is needed.
This is the SNMP version of the protocol to be used in communicating with the SNMP
agents on the server.
13. In the User Name field, type the user name.
The user can query only for information.
Your entry must be in any alphanumeric format and up to 50 characters in length.
14. (Optional) In the Authentication Password field, type the security password.
Your entry must be in any alphanumeric format and up to 50 characters in length.
Note:
If you did not do Step 14, you cannot do Step 15.
Note:
15. (Optional) In the Privacy Password field, type the security password.
16. In the IP Addresses for SNMP Access section, check either:
- Any IP Address, and go to Step 19.
- Following IP addresses, and continue with Step 17.
SNMP Agents
Issue 1 June 2005 581